Subscribe to Our Newsletter Advertise
Close



Page 2 of 2 FirstFirst 12
Results 11 to 12 of 12
  1. 11-30-2015, 09:59 PM #11
    Fantastic Brass Ninja
    Fantastic Brass Ninja is offline
    Student Fantastic Brass Ninja's Avatar
    Join Date
    Nov 2015
    Location
    Ont, Canada
    Posts
    10
    Quote Originally Posted by LuckyImperial View Post
    USB cable, hub, baud rate? There may even be a connection timeout setting in the configuration tool. I'm not familiar with that issue though.

    Do you use SD card printing?

    Make sure your Repetier Host is latest (v1.6).


    Ok, so. Repetier does have a connection time out setting, and its set to 40. Baud rate = 250000. The USB was the one supplied by MG's, but I swapped it for a 10' cord just now. Still nothing. The host is up to date (V1.6.0)

    Oh the joys of trouble shooting, eh?
    Reply With Quote Reply With Quote
  2. 12-01-2015, 02:27 PM #12
    LuckyImperial
    LuckyImperial is offline
    Technologist LuckyImperial's Avatar
    Join Date
    May 2015
    Location
    Campbell, CA
    Posts
    162
    I noticed on my printer that I actually get the same message. I guess I just ignore it. Does it affect prints?
    Reply With Quote Reply With Quote
Page 2 of 2 FirstFirst 12
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules