Results 1 to 3 of 3
-
11-16-2015, 04:22 PM #1
- Join Date
- Nov 2015
- Posts
- 3
Top and bottom layers out of place with Freaks3D printer.
Recently got a Freaks3D printer, first printer I own. Had many problems building and now printing. Printer problems are endless. Not sure why this happened to this print, it's just a 15mm test cube. Also it was oozing at the corners of each layer creating a blob.
-
11-16-2015, 04:57 PM #2
It looks like your printer slips 10mm on the one axis every now and then. Did the nozzle dig in on the layers it had a problem doing?
-
11-19-2015, 12:35 PM #3
- Join Date
- Nov 2015
- Posts
- 3
Tested the belt that move the bed and it isn't as taught as it should be. How do I make it taughter, I tried pulling the ends of it but nothing. The nozzle doesn't dig in only blobs at the corners
Last edited by ThomasB96; 11-19-2015 at 10:26 PM.
Do bed magnets deteriorate.
04-29-2024, 01:35 AM in General 3D Printing Discussion