Results 1 to 6 of 6
Thread: PLA extrusion problem
Threaded View
-
11-14-2015, 02:48 PM #1
- Join Date
- Aug 2015
- Posts
- 17
PLA extrusion problem
Hi, I started printing in PLA and everything was fine, but recently, the filament stopped extruding continuously through the nozzle even though I didn't change any of the settings. I'm pretty sure it has something to do with the filament because I switched to abs and it worked fine, even on nylon and ninjaflex. It had been raining for a few days so I thought maybe it absorbed some humidity so I followed this http://www.taulman3d.com/drying-materials.html to try and dry it for about 5 hours. Still, i can see the extruder skip some steps at intervals. I am printing on an airwolf HD. I was printing at 195 just fine for a couple of weeks, then I tried 200 and 205 once it started malfunctioning but no luck.
Any help is appreciated.
Extruder not feeding during print,...
04-28-2024, 02:02 PM in Tips, Tricks and Tech Help