Results 1 to 2 of 2
Thread: frustrated need help
-
05-24-2015, 11:45 AM #1
- Join Date
- May 2015
- Posts
- 6
frustrated need help
tryed so many different firmware setups and just getting fruststrted prusa i3 1.4 step arduni 2560 mks genv1.1
when home is pressed are the axis supposed to go to end switchs
if i home a axis it just moves a mm or 2 and stops does not go home
is about 10mm from bed when i try to print so just blobs everywhere and comes out fast
where would i get someone to explain what each step does in marlin
or the best setup as there sso many different ones
or anyone in derbyshire near burton upon trent who could help me out
please help had enough now also i have a lcd controller can i alter all things in this instead of marlin firmware
heres a video of what printer does when use in pronterface
old firmware upload
as new from github wont upload freezes on compile any ideas
also is replicater firmware an diffrenthttps://youtu.be/9S_JLNvni8w
-
05-28-2015, 05:39 PM #2
- Join Date
- Jan 2014
- Posts
- 462
In short, yes. If your endstop switches are not wired or configured correctly, though, the axes won't travel toward them.
I looked at your video and it looks very much like there's a problem with the end stops. Two things to check: firstly that the wiring is OK and secondly that they're configured correctly. First make sure that the wiring is OK, then send M119 to the printer. This will tell you whether or not they're triggered. If the Z axis is raised, but M119 tells you the end stop is triggered, then you need to invert them in the Marlin configuration (search for the end stop section and it should be reasonably obvious where to invert them - if not, ask here). From the video, the Z axis raises when you try to home it, but then won't go down. This is generally what happens when the end stop isn't configured correctly.
You might have the temperature a bit high. What type of plastic are you using and what temperature are you printing at? Also, fixing homing and end stops will help with the height above the bed problem.
Here's a good start: http://solidutopia.com/marlin-firmwa...r-guide-basic/
Ender 3 Neo - Jam Problem
05-08-2024, 03:06 PM in Tips, Tricks and Tech Help