Subscribe to Our Newsletter Advertise
Close



Results 1 to 6 of 6

Threaded View

  1. 10-20-2015, 08:57 PM #1
    dustmann
    dustmann is offline
    Technician
    Join Date
    Nov 2014
    Location
    New Orleans
    Posts
    50

    Question Why are my corners raising up? (on top of print, not lifting off bed)

    This seems to be a new issue since I have adopted slic3r 1.2.9. My corners are raising up significantly, and it gets progressively worse with round slopes (e.g. when printing a sphere). It looks like it is extruding too much in the corners, or not retracting enough maybe? I have attached some examples of a perimeter width test (the parts don't quite fit, but I think if I can solve the corner round/overextrusion they may be close).

    Edit: I am printing natural PLA at 200* with 60* bed temps and 15% infill with a part cooling fan running at 100% for the duration of the print.

    IMG_2920.jpgIMG_2921.jpg
    Last edited by dustmann; 10-20-2015 at 09:29 PM.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules