Results 1 to 3 of 3
Thread: setup help
-
12-02-2015, 01:39 PM #1
- Join Date
- Nov 2015
- Location
- Enfield, CT. USA
- Posts
- 2
setup help
I have a prusa i3, it came with an auto bed level sensor, this is a green box with a red light. Where does this plug into the board ?
-
12-02-2015, 03:40 PM #2
It depends upon how you have your printer configured. In Configuration.h you will be looking for Z_MIN_PIN. It might be on that pin unless you have dual Z Min endstops defined.
-
12-02-2015, 03:53 PM #3
- Join Date
- Nov 2015
- Location
- Enfield, CT. USA
- Posts
- 2
Nothing setup yet, it's all new to me, trying to install pronterface now, getting no were, can't find a install file
Please explain to me how to...
Yesterday, 02:43 PM in 3D Printer Parts, Filament & Materials