Strange numbers in Code ??

[EagleSeven]

I did a print with 'layerWidthRatio' set to 1.6 and it looks a little better than the 1.5 setting.

Anyone know what the Upper and Lower Limits are, for that setting ??

I can not find any good info about limits online.

How Far can I Go !

[EagleSeven]

!!! No one Knows ??

Looks like I've Stumped the Experts Again ! LOL

Oh well, I guess it's Back to experimenting !

[Mjolinor]

There are no experts here.

[EagleSeven]

There are no experts here.

I can think of several ways to reply to That,
but All of them will probably get me in Trouble !

[EagleSeven]

Any one know what the 'Coarseness' setting Does in Slicer software ?

"coarseness": 0.0001,

What does it change ?
What are it's limits ?
It's such a small number, then why shouldn't it just be Zero ?

[EagleSeven]

Any one know what the 'Coarseness' setting Does in Slicer software ?

"coarseness": 0.0001,

What does it change ?
What are it's limits ?
It's such a small number, then why shouldn't it just be Zero ?

This is the Only Info I could find about 'coarseness' setting:
I still don't understand what it Really Does ??

"coarseness". Decimal, [0,0.1]
The "coarseness" setting is used to simplify the outlines of each layer before the toolpath is created.
The slicer will combine adjoining segments that are nearly collinear using the value set here.

Setting "coarseness" to 0 will result in no line segments being combined and a more detailed printed object.
A higher value will result in a less detailed printed object.
Setting "coarseness" to 0.1 could result in all line segments being combined until there is nothing left, and is not recommended.