Subscribe to Our Newsletter Advertise
Close



Page 3 of 3 FirstFirst 123
Results 21 to 25 of 25

Thread: Marlin 1.1

  1. 09-26-2015, 03:49 PM #21
    Roxy
    Roxy is offline
    Super Moderator Roxy's Avatar
    Join Date
    Apr 2014
    Location
    Lone Star State
    Posts
    2,182
    Are there two pegs that come up higher than everything else? Or is that closest mound of plastic a result of the nozzle driving into the part? If there are supposed to be two pegs of plastic, it looks like that close one is getting too hot. You can add a cylinder that goes up a little higher than the extruder part just to burn some time between layers. That will let that peg cool down and come out better. Maybe a cylinder that is 1" in diameter would do the trick.
    Reply With Quote Reply With Quote
  2. 09-28-2015, 08:55 PM #22
    adamfilip
    adamfilip is offline
    Engineer
    Join Date
    Dec 2014
    Location
    Canada
    Posts
    498
    yep there were suppose to be two mounds.. the nozzle and heating element went down. it printed fine. just my gcode error in the ending script
    Reply With Quote Reply With Quote
  3. 10-18-2015, 07:12 AM #23
    adamfilip
    adamfilip is offline
    Engineer
    Join Date
    Dec 2014
    Location
    Canada
    Posts
    498
    Is marlin 1.1 available for Due with Radds?
    Reply With Quote Reply With Quote
  4. 10-18-2015, 03:47 PM #24
    Roxy
    Roxy is offline
    Super Moderator Roxy's Avatar
    Join Date
    Apr 2014
    Location
    Lone Star State
    Posts
    2,182
    What is a Due with Radds ? Marlin should run on pretty much any Arduino board setup for 3D Printers.
    Reply With Quote Reply With Quote
  5. 10-19-2015, 07:04 AM #25
    adamfilip
    adamfilip is offline
    Engineer
    Join Date
    Dec 2014
    Location
    Canada
    Posts
    498
    http://reprap.org/wiki/RADDS
    Reply With Quote Reply With Quote
Page 3 of 3 FirstFirst 123
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules