Qidi Tech 1 - Replicator 1 clone

[Syd_Khaos]

Some pictures would help. :-)

Help me find my phone and I will get right on that lmao......

Its one of those days I tell ya, about to take my tail back to bed till its tomorrow.

[wirlybird]

Its just a temp display with a wire probe on it that i have attached to the back corner of the inside of the printer so i can see what the temp inside the printer is wile it is printing.
the desplay and probe i got off ebay for like $12 and it is meant to be for a water cooling set up in a computer but i just have the probe hanging in mid air so it takes a measurement of the ambient temperature inside the printer.

i used fusion360 to design a mount for the probe and the mount for the display it self.

if you look up digital temperature gauge on ebay you will finde it

How did you wire up its power supply?

[Warren O'neill]

How did you wire up its power supply?

i have added extra led's to the inside of the printer so i just wired it up to the same 12volt power supply i use for them

[Talon 3D]

The PSU in the system supports more things as well. Especially some simple stuff like LEDs and gages. Simple 12v PSU.

i have added extra led's to the inside of the printer so i just wired it up to the same 12volt power supply i use for them

[Warren O'neill]

The PSU in the system supports more things as well. Especially some simple stuff like LEDs and gages. Simple 12v PSU.

ok i was under the assumption that the printer ran on 24volt not 12.

if some one can confirm this will change it so that it all runs off the psu in the printer not a seperate 12v psu.

[wirlybird]

So now I have two bad spools of ABS from Makergeeks and they are unresponsive.

[rcleav]

ok i was under the assumption that the printer ran on 24volt not 12.

if some one can confirm this will change it so that it all runs off the psu in the printer not a seperate 12v psu.

You are correct it has a single 24v power Supply.

[Talon 3D]

12 volt fan works fine connected to it manually though.

You are correct it has a single 24v power Supply.

[wirlybird]

Anyone using MG raptor filament? What are the temps?

[DaveB]

Anyone using MG raptor filament? What are the temps?

I've used the yellow MG PLA Raptor material at 230/60. Great stuff too. I've also got rolls of green and white but have not printed anything with them yet. Syd has used it on some of his projects also.