Qidi Tech 1 - Replicator 1 clone

[wirlybird]

A little Christmas fun with vase mode.


[IMG][/IMG]

[cncartist]

That looks awesome too! What filament did you happen to use for that print?

[wirlybird]

This is Hatchbox translucent green. It is lighter than I would like but prints really nice. I have printed these between 190 and 215 and seen no noticeable differences in color or print. Seems to be pretty stable. The translucent red is vivid and rich.

[DaveB]

A little Christmas fun with vase mode.

Looks great W! I had collected that one as well but had not yet printed it.

[wirlybird]

Looks great W! I had collected that one as well but had not yet printed it.

It prints nice. I want to make a hole in the bottom for a LED tea light. You will need to scale a bunch, the thing is huge!

[ycoidi]

Hello!

First time poster! I'm sorry if I missed this in 379 pages (I kinda skimmed them), but I just received my printer and am all ready to set it up. The included SD card is completely blank (no instructions, software, etc.).

Where can I track down an image of the SD card (or, at the very least, get the setup instructions)?

Thanks!

[DaveB]

Hello!

First time poster! I'm sorry if I missed this in 379 pages (I kinda skimmed them), but I just received my printer and am all ready to set it up. The included SD card is completely blank (no instructions, software, etc.).

When can I track down an image of the SD card (or, at the very least, get the setup instructions)?

Thanks!

Contact Emily at QiDi. Her email address is emily@qd3dprinter.com

[ycoidi]

Contact Emily at QiDi. Her email address is emily@qd3dprinter.com

Thanks!

I'll give it a shot!

[DaveB]

Thanks!

I'll give it a shot!

I'd suggest sending her an email now. She is 12 hours ahead of EST somewhere in China. Just coming up on Lunchtime.

[ycoidi]

I contacted her and got all the files. That was quick! Thanks for the help!