Printing Spaghetti as Overhangs (sorta?)

[BradR97]

It finished a while ago and upon inspection it is a bit better, i measured the diameter of the filament at it was 1.8mm so I put that into Slic3r settings. I used the red ABS from PrintME3D this time. I'l post pictures tomorrow (UK time) when its a bit better lighting.

I need to get some more filament but I am unsure whether to get ABS or PLA. I can't seem to get the PLA I have to print properly without it jamming up and making an awful clicking sound after about 2 minutes. Does anyone know how to fix this? It's a shame because I've heard PLA is "easier to print" and is more suitable for most applications but with my experience I just want to avoid it.

Finally, Are any brands better than others? I'm looking at getting some PrimaABS or PrimaPLA rather than PrintMe3D's filament although I can't decide for the life of me whether to get bright green, orange, yellow, blue or grey received_967774903265133.jpg