Before I take my printer apart to test the plastic X-Motor Mount, it just seemed to make sense to work on the X-Idler plate also, especially since most of the hole patterns are the same. I had some nice suggestions on the design of the X-motor, so thought I would post a photo of the X-Idler model to see if anyone has some ideas for enhancements to this. I just made it as a simple plate, but could add a little reinforcement to it along the top or middle. I followed the same curve design as I used on the X-motor mount design. I will probably add another hole to the upper right as well.
X-IdlerPlate_rev1.jpg