Hello,

I am newer to the 3D Printer world I purchased a XYZ Da Vinci and Returning that Crap, didn't make that great of prints and then the cost of Filament for 2 rolls cost me around $60, each one is only around 600 Grams so I was basically paying triple the price of normal Filament, and then with the new one can't change firmware, just wasn't worth it.

So after research I was looking at making my own I am a Field Tech so I have the full ability to build just about anything, but after looking on ebay this CTC printer runs around $500 and doesn't look that bad.

So my general questions is do you guys think that The CTC is worth the money?