Results 1 to 5 of 5
Thread: printing sticks is it possible
-
05-13-2015, 11:38 AM #1
- Join Date
- Apr 2015
- Posts
- 3
printing sticks is it possible
Hello,
I should print sticks with diameter of 0,5mm x 20 mm.
But the sticks should stand.
Is this possible?
When I use skeinforge with layer setting of 0.05mm sticks with a diameter of 1mm x 1 mm is printed.
0.5mm x 0.5mm are not in the gcode-file. Are there settings which I should tune?
My printer is Wanhao Duplicator 4S.
Thanks
Hans
-
05-13-2015, 12:43 PM #2
half mm 'stick'
given that your extrusion width is 0.4mm, you are seriously going to struggle with a 0.5 mm column.
And it's going to be weak as anything.
Also do you mean: 0.5mm or 0.05mm you typed both - 0.05 is not possible with fff. Hell 0.5 probably isn't unless you have a 0.25mm nozzle.
1mm thick is probably the best you're going to get.
-
05-13-2015, 12:53 PM #3
- Join Date
- Jun 2014
- Location
- Burnley, UK
- Posts
- 1,662
Bore the nozzle out to 0.5 and extrude then cut to length.
-
05-14-2015, 07:58 AM #4
Wouldnt it be easier to purchase 2-4m lengths of your diameter of choice and then cut it down from there?
Something like this http://www.amazon.com/Plastruct-Ar-2...2&keywords=rod
-
05-14-2015, 04:40 PM #5
- Join Date
- Aug 2014
- Location
- Montreal, Quebec
- Posts
- 576
Copper wire, needle have their own standard set. You may want to check if it solve your problem before throwing yourself into 3D printing.
Ender 3 Neo - Jam Problem
Yesterday, 03:06 PM in Tips, Tricks and Tech Help