I'm printing an oculus rift clone but the print is such that the base has very little area.
The frame is thin and for whatever reason, MatterControl refuses to print a raft. MatterControl is a piece of crap but it is still better than the other programs I've tried like Cura (print button doesn't work) and repetier (doesn't even attempt to print. Says print finished without doing anything).

I've tried various surfaces:
1. Paper
2. Kapton Tape
3. BuildTak
4. Blue Masking Tape from the Dollar Store

No matter what, the damn filament doesn't stick!
I've tried adjusting the height of the leveling various heights and it sticks for a few layers and then it just fucking HHAAAAS to detach.

I've wasted an entire roll and weeks trying to get the damn thing to attach.