Hello folks. Hope I can get some newbie assistance here.

I just bought a Monoprice Maker Select V2 which, I am told, is a rebranded version of the Wanhow Duplicator. My problem is trying to set up Cura.

What settings do i use? I attempted to do a "Custom" printer setup and waded through all the (thousands???) of settings but in the end, Cura does not recognize the printer is even plugged into the USB port. I can print from the micro card and the test parts included with the printer pre-installed on the card print OK, but I would really like to print from Cura if possible.

Any help would be appreciated.

Tom