Makerbot z18 extreme stringing of walls

[MANICX100]

http://i.imgur.com/FJlSArE.jpg

Any advice to recify?

Thanks guys

[3dkarma]

From the look of the print, it looks like it was oriented with the wall you're pointing at at the top, facing down? If so, that's a really long bridge and I'm not surprised it's drooping. Can you rotate your print 90 degrees and reorient it so it prints in the orientation you've photographed it? I can't see the rest of the piece from your photo, but from what I can see it should print OK that way an you won't get the drooping.