Results 1 to 1 of 1
-
05-17-2019, 11:38 AM #1
- Join Date
- May 2019
- Posts
- 5
missing lines, globs, bad exterior
Hello, My Wanhao/monoprice IIIP printer is a couple years old and all of a sudden I started having issues getting good prints. I have found a host of problems, including:*Extruder gear flattened - moved it for a bite on unused area*Hot end Heat sink fan not turning - replaced.*Wavering temperature - did PID auto tune.*burnt/shrinking hotend Teflon inner tube - replacedpicture of the printing I am getting at the moment on first layers. Also, a picture of a print that was run out. I am using PLA+ and am printing at 240-250. I know you would say that is way too high, my before my current issues this is the temperature that was generating good prints. When I first got the printer I was at 225-230 and over the 2 years it has crept up. I also have tried replacing the thermocouple, but did not help.Any insight, help, or suggestions are appreciated. Pulling my hair out at the moment.
Please explain to me how to...
Yesterday, 02:43 PM in 3D Printer Parts, Filament & Materials