MKS BASE V1.1 Firmware Requests Please

[Shannonb1]

I have an Aurora3d Prusa i3 using a MKS Base v1.1 atmega board. I have tried repetier and I can get pretty much everything to work. The only issue is the extruder motor wont run. I have verified that the motor does work by plugging it into a different controller port.

anyone have the original firmware please?

Here is the printer

http://www.amazon.com/Aurora3D-Print...XT47Y26BGFTEDT

[secretman]

easy...
http://reprap.org/wiki/MKS_BASE

[upen]

Have you solved the problem yet?

I have an Aurora3d Prusa i3 using a MKS Base v1.1 atmega board. I have tried repetier and I can get pretty much everything to work. The only issue is the extruder motor wont run. I have verified that the motor does work by plugging it into a different controller port.

anyone have the original firmware please?

Here is the printer

http://www.amazon.com/Aurora3D-Print...XT47Y26BGFTEDT

[legozebra]

Have you solved the problem yet?

Submitted request to Aurora (no reply) even called Aurora support number (no voice mailbox, no answer) in China (big surprise-not). Was going to try Marlin FW so could add auto-bed-leveler but don't want to break/disable my printer in the process... Anybody have a working FW for the Aurora Prusa i3? (MKS_BASE_V1.1 Controller)?