Hacker and maker Evan Long has put a serious spin on the Etch-a-Sketch for enthusiasts of the retro toy, as well as for those enthusiastic about hacking, 3D printing — and producing amazing artwork. With Arduino software, some simple hardware, and a bit of 3D printing, you can rev your Etch-a-Sketch up quickly, following her example. Long created an Etch-a-Sketch version of the Mona Lisa as an example of what her hacking concept can create. Check it out over at the full article: http://3dprint.com/41841/etch-a-sket...printed-parts/


Below is a photo of the setup for the Mona Lisa sketch with everything wired up: