I'm trying to print a small bust with my Flashforge Creator using the Makerbot Desktop software.

I want to print the model with ABS filament from the right extruder and the scaffolding using HIPS filament from the left extruder. I've set up my model in the software and exported it as an .x3g file with the extruder temperatures set to 230 degrees celsius. However, when I attempt to print, the extruders are only heating up to 38 degrees C. No target temperature appears as the printer heats up the extruders. The target for the base plate appears correct (110c/110c) but there's only one number showing for the extruders (38c) and it won't heat past that temperature.

I'm using the Replicator Dual as the target printer in the software and tweaking the settings a bit (resolution .15 mm; Raft on; Supports on; Left extruder: Makerbot dissolvable filament; Right extruder: Makerbot ABS filament, etc.)

Is the printer changing the temperature settings or am I setting it up incorrectly in the software?

Any help would be most appreciated. 8- )