Results 1 to 3 of 3
Thread: Thermistors - I am confused.
-
03-29-2016, 02:05 PM #1
- Join Date
- Mar 2016
- Posts
- 2
Thermistors - I am confused.
Well basically what happened is my cat ate the thermistor that came with my Cobblebot. Really, more likely the cat chewed it in half and I didn't know what the other half was so I threw it away.
Anyways, as you can tell I am new the 3d printing, and I need a thermistor. I am thinking about getting these ones, http://www.amazon.com/RepRap-Thermis...A1IGO1KB58B88F
but I don't really know if that will or or if it's what I need? I just want the cheapest option to get my printer going.
The hardware specs are a RAMPS 1.4 board, and the printer uses a Hexagon Hotend. Will that thermistor work? And also, which type would that be considered? Is it a type 1?
Thanks for reading!
-
03-29-2016, 04:34 PM #2
This would be a Type 11 Thermistor in Marlin's Configuration.h. You would replace the bad one with this and edit the table to say you have a Type 11 there now. $.99 with free shipping.
http://www.ebay.com/itm/1-pcs-100K-O...QAAOSw~uhUqRJb
-
03-29-2016, 05:00 PM #3
- Join Date
- Mar 2016
- Posts
- 2
New to 3d printing looking for...
Yesterday, 12:56 AM in Tips, Tricks and Tech Help