I just verified that my hot end readings are accurate. I have a multimeter with a thermometer and they basically read the same values sticking the thermistor in the slot and the multimeter in the...
Type: Posts; User: DanB
I just verified that my hot end readings are accurate. I have a multimeter with a thermometer and they basically read the same values sticking the thermistor in the slot and the multimeter in the...
Hi guys,
I know this issue has been covered far and wide on different forums but I am having a hell of a time just getting my i3v to extrude on pronterface, let alone actually make something! With...
Hi guys,
I know this issue has been covered far and wide on different forums but I am having a hell of a time just getting my i3v to extrude on pronterface, let alone actually make something! ...
Thanks guys, I got it figured out.
Hi guys,
I hooked up the heat bed relay by moving the 11 amp power supply directly to the relay and followed the instructions per the guide. There are now no wires going to the 11 amp power...
Hi guys, I have an 8" prusa i3v and I'm trying to install a heat bed relay. Does anyone know which wires from my antec power supply to plug into the relay? There were no instructions on this that I...
Title pretty much sums up what I'm looking for. I need to print abs. I had no luck with slic3r, it kept crashing. If anybody has the settings or can point me in the right direction I'd greatly...
Thanks, I tried it and it worked. I thought about doing this earlier but was afraid I'd damage something.
I'm finishing up an i3v and on initial testing the x axis goes in the wrong direction. My understanding is that this is a firmware issue of some kind? How do I fix this?
Thanks guys, I got it figured out now.
Finishing up on my I3v and I tried to wire in the power supply using an antec vp450 and nothing happened when I turned it on? Could it be possible that I crossed some wires after I snipped the tips...