Got an small update in the meanwhile:
- So I've switched the cables on the motors with each other, does not seem to make anny diffrence. So I asume the stepper-driver settings are equal, otherwise...
Type: Posts; User: Rockel83
Got an small update in the meanwhile:
- So I've switched the cables on the motors with each other, does not seem to make anny diffrence. So I asume the stepper-driver settings are equal, otherwise...
I have an A20M dual extruder printer of Geeetech. It has 2 similar extruder stepper motors which feed 1 mixing nozzle via seperate bowden tubes.
I'm bussy re-calibrating the printer. And...
Oh thanks for the tip! I could try this, since it's almost a full spool of filament. :)
It was laying around for over a couple of years. I had it put in a plastick sack, but gues it still could have...
Thanks for the response.I've measured 120mm from the entry point, and then measured the remaining distance after extruding 100mm. So this is somewhat the same technique. Another possibility is to...
I'm calibrating my new printer, Geeetech A20M at the moment. It's printing fine so far, but seems the step/mm values are a bit off, because the dimensions of printed parts are a bit off. So guess I...