Search:

Could it be something with X offset? Possibly raising the hot end between layers? Any feedback?

Am using the built in slicer in MakerDesktop, they use makerbot slicer. I have tried different infills and layer heights to see if I could shake something loose in the slicer. Guess I could load...

I am running a Powerspec 3D Pro (private label clone of Flashforge Creator Pro) with 1.7 ABS, .2 layer height, 50 speed. I use maker desktop software. I am getting holes in the top of my prints. I...

I was having the same problem and decided to scrap PLA. Once I went to ABS I didn't have the holes on the top. Also had the problem with older filament. Once it soaks up a little moisture it may...

I have a Powerspec, DaVinci XYZ 1.1 and Airwolf 5.5. The Powerspec blows the other two away. Using a two headed printer can be a pain because even when leveled the second head often knocks the...

I can help. Reach out to me at 214-659-3003. have used the powerspec for a full year and an Airwolf 5.5 for another two. Be happy to see what we can do.

One question, if I am over extruding why won't the top layer print complete. My assumption was that I was under-extruding (but I am guessing). I will bump the extrusion down in increments of 5% to...

Am using an Airwolf 5.5 printer. PLA at 205 degrees on blue tape, have tried temps from 190 - 215. Printing at 60 per second. Have tried every level of infill from 10 to 100. Am just getting...

Will the new block you are selling fix my issue? Am not sure by looking at the picture if what I have will plug into it without problems.

It is a PowerSpec 3D Pro which is a private label of the Flashforge Creator Pro. Have had it about 5 months. Everything was fine until one day it wasn't. One head is visibly lower than the other...

I appreciate the great pictures. However, when I tried to remove the screw I found that my hot ends (and the whole square heating element) screw in instead of slide up. My right side is about 1mm...