Search:

I agree completely, dont usually do so many in any experiment , BUT when you change from ABS to PLA some other things need to change like the BED TEMP and NOZZLE TEMP. So 3 of variables HAD to...

Thanks for the reply, I switched from ABS to PLA on the creator pro, adjusted the layer level to 2.0 from 2.7 and increased the feed rate. I still get to where some of the pattern is laid down and...

Hello,

I have a mesh or crosshatch like pattern square in shape about 3inx3in but it is only .25mm thick. The CUBE prints this out just fine but the Flashforge Pro misses on more than half the...

any particular method to apply, how often do you need it.

Alan

Hi,

After a few days of printing I now get a squeaking noise at start up and print ending. Is the recommended lubrication method?

Thanks!

Bobbler,

This file actually prints some material and in the proper shape, it is just so little material I have to scrape it off. Was this your experience? On the Qube it prints out a little over...

Hello,

I have an STL file that converts and prints fine on a CUBIFY 3D printer. But when I import the same STL file into flashforge G software and generate G code then print on flashforge PRO it...

Hi,

Just got an flashforge pro. The instructions I followed for leveling the bed had me turning one screw at a time then moving to the next position . By the time I had adjusted all 3 screws it...

Oh, I forget these forums are world wide, I am in sunny South Florida a freezing 41 this morning coldest in 4 years. Should be 80 on Sunday though. I will see if lowes will cut a pane up for me. Then...

Thanks for the quick reply, is there somewhere I can by glass suitable for this application cut to fit?

Hi,

Just getting set up and the capton tape has already torn. The flashforge Pro came with a roll of Blue tape. Can I just tape over the capton or is it better to remove it. Any tricks in...