I do prop 3D Modeling from photos and hate trying to create good Topology and was wondering if there any software out there where you can insert a photo and it draws the topology for you
Type: Posts; User: crazymonke42
I do prop 3D Modeling from photos and hate trying to create good Topology and was wondering if there any software out there where you can insert a photo and it draws the topology for you
I noticed when i connected octoprint to my ender 3 i got the dots randomly through out my print at first i thought it could have been the seam but isn't. Also i can now see infill lines on mt prints...
i use the slicer cura and when even i close the application when i reopen it i have to do setup wizard i have tryed unistalling it and reinstalling it i have updated it not sure what to do
yes it occurs at the same height i use cura
on my prints i have been noticing a lip near the bottom of my prints not sure what is causing this
i have found some people at school that are going to fix but thanks so much for all your help i have learned alot from you Thxs!!!
my fan i have turned off and i use cura as my slicer and i have a .4 nozzle size i will run my temp tower tommrow
Are yopu still able to help me??????
So I just bought a new heat box which came with a new hot end and nozzle and I do not hear any clicking I noticed this when I was doing the temp tower I could not do it as the filament did not come...
The nozzle looked like it was not dispensing fast enough
can you find me a video
and how would i do a temp tower
sry for posting twice
what temp should i print at
I am using 1.75mm pla and i dont know how to do a temp tower
i am printing with pla 1.75 filament and i dont know how to do a temp tower
i have only had one filament it is solutech it is around a year old and was stored on the printer the hot end was set to 220
the filament did not look very melted though
so i lossened the bolt that was holding the thermistor and plugged it back in and it is reading 26 also it is putting out filament now
357 for hot end 22 for bed
i have the first firmware
ok thxs we will start off with trying to get the temp to read right and getting the nozzle to put out filament
should i go back to the old one and have you help me fix the printer from there our should i keep the new one on and have you help me fix the temp issue and fix the filament not coming out or should...
so i swapped the wireds i mixed up and the hot end heated up to 350 not the 220 i told it to (at least thats what the screen said) i then swapped them back and got the same thing. I just bought a new...
I have not not gotten a chance to test i have had a lot happening lately sry but i should hopefully get to test wendsday that is my free day but one problem i havbe now is when ever i heat up my hot...
Thx's so much i just replaced a part i am going to test it tommrow i mixed up two wires and then i will tell you the probelms if there are any
But the probllems i was having were layers not...