I do have the heat on. I thought of using a sheet of glass with hairspray and setting the z offset... Anyone tried that yet?
Type: Posts; User: JeffKling
I do have the heat on. I thought of using a sheet of glass with hairspray and setting the z offset... Anyone tried that yet?
AHH I think I need supports turned on for the X. There is a pocket underneath.
OK. Here is my largest print ever.
Couple of issues...
Raft problem: Same as before, but I have not tried the new setting yet.
Raft Warp: The upper right hand corner cam up a couple mm. ...
One issue I am having (before I used your settings) is separating the part from the raft. What setting affects the material between the raft and the part?
Thanks again Dragon. I am going to use you setting as a baseline to see what happens.
That site is getting some INCREDIBLE prints. If I can get them half that good I will be happy.
I did contact support and looks like the parts will be on the way.
As for the temp. I was trying to print ABS which apparently it will not do. Do you run your PLA at 35C chamber temp? I will...
Dragon,
That may have honestly been the best reply I have EVER received in a forum. Thank you VERY much...
I wanted to get that out there. I do not have time to reply point by point right...
Does anyone have a Z18? Are you getting good prints out of it?
I want to start by saying I HATE this printer. I cannot get 2 consecutive good prints from it.
Problems...
Unpacking: ...