Interestingly I am having problems with the white ABS as well. My issues, however, are different.
The first thing I would recommend for printing in ABS is cleaning your print bed. First make sure...
Type: Posts; User: 3Dog
Interestingly I am having problems with the white ABS as well. My issues, however, are different.
The first thing I would recommend for printing in ABS is cleaning your print bed. First make sure...
Hey Timmy. I initially had a problem with my SD card on my Creator Pro. I chalked it up to running everything on my Mac and possible compatibility issues. Then I did some research. I found another...
I have no experience with makerbot software. However in replicatorg, onboard preferences, there is a button to click that says "override Gcode target temperatures". Perhaps there is something similar...
Thanks for the info. I'm a little confused about the temperature test. Are the number randomized so its easier to see potential differences between gradients? Also based on your experiences with...
Im using replicatorg. When I run gcode a window pops up with a couple values to edit. I input feed rate and travel rate as well as nozzle temp. I always run my PLA at 200C. Then I convert the gcode...
The intended design can be found here: http://www.thingiverse.com/thing:630314.
You are correct, there is a large amount of support material that needs to be removed. However that is not the...
I am new to printing as well but in the few days I have been learning I learned a few things.
1. Blue painters tape is AMAZING for getting PLA to stick. Use it. Cover the whole bed evenly, no...
Hello everyone. I am new to the arena and the forum. I have been reading everything I can to get better. I am trying to figure out what would cause the terrible quality print that you see in the...