I have been looking online trying to find something that talks about this issue. My printer is doing a benchy and when it starts to do the roof it is starting in the center of the roof. There is no...
Type: Posts; User: cripto101
I have been looking online trying to find something that talks about this issue. My printer is doing a benchy and when it starts to do the roof it is starting in the center of the roof. There is no...
Did you add anything to it? With the glass bed you might need to make adjustments to your offsets. and adjust your z axis stops. This might help with that a little.
Haza!!! It lives. The printer is working really well now. Thanks!
Thank you so much Tommy Dee. I will do that. Once I get it in I will let you know if that was the issue.
So not sure which one I should get...
You know what it could be that the original was 24 volt and i put in a 12 volt. That sounds like it could be the problem. Will I need to send it back and get a 24 volt?
Thank you for the response TommyDee. I did check it both with the bed heated to temp and the hot end heating up and with just the hot end heating up. It maintained a stable voltage. It is...
So after some fiddeling I have been able to get the heat bed up to temp but the hot end will only reach 145 degrees and than the system goes in to the E1 error. I have checked all the connections...
I did a search but could not find much to help me on this. I had a power supply burn out due to a faulty fan. I replaced it with a mean well nes 350 12. After i replaced the power supply the bed...