My origin, 0,0, is at the left front.
Type: Posts; User: Bob
My origin, 0,0, is at the left front.
Apparently I don't understand the topology map or I have something else really wrong.
In the map above I read that the back left, -0.73591, is low and the right front, 1.25075 is high. Is that a...
Sorry for the delay in answers. I run a home business, machining, and I have jobs to complete. I'll try to do better tomorrow.
BTW, I changed from 3 point leveling to 4.
I see my bed isn't very level.
ENDING:G29 n5 T V4
Roxy's Enhanced G29 Auto_Bed_Leveling Code V1.81:
Full support at http://3dprintboard.com
Bed x: 2.00 y: 1.00 z: 11.53
Bed x: 45.00 y: 1.00 z:...
Here you go. Looks good to me, but what do I know!
>>>m48
SENDING:M48 "Loose"
M48 Z-Probe Repeatability test. Version 2.00
Full support at: http://3dprintboard.com/forum.php
Mean: 17.065334...
Hello all.
Well, I'm getting very frustrated. Hope someone can help me.
Here's my setup.
Prusa Mendal printer.
Arduino>BeckDac firmware.
Auto bed leveling.
Bed is 1/2" aluminum tooling...
Thanks Roxie for your help. I have the code the same now. I will try to load it up later today and see what it does.
Thanks again. I REALLY do appreciate it. Other forums just don't seem to want to...
Hello all. I've been printing, off and on, for a couple of years. However, my prints were hit and miss. Sometimes perfect, sometimes not so much. Lot's of time and filament wasted.
I am now in the...
Thanks Davo.
Thanks Davo. I'm just confuse about this offset thing. My probe is 59mm behind my extruder. Just can't get it any closer.
My start code is.
G28 X0 Y0
G0 Y50 ; To get the probe back on the bed
G28...
Thanks tpete61, but that's not it either. Bed size is right.
yes, prints are to scale. thanks for your reply.
Hello all. Pretty new here. Been doing a lot of lurking.
I have a Prusa mendel, homemade. Using Marlin, with auto bed leveling, latest version and Pronterface. Really like Repetier better but...