Hi again,Finaly I think I have resolved the problem.-I have updated the Cura to 4.4.1 ( I don't think that this was the problem)-I have observed that I didn't set up a material profile. So I set up...
Type: Posts; User: freddygitar
Hi again,Finaly I think I have resolved the problem.-I have updated the Cura to 4.4.1 ( I don't think that this was the problem)-I have observed that I didn't set up a material profile. So I set up...
I have updated the belt , I mean print a tensioner for it. It work perfectly the belt is tight enough but after the belt update I have the same problem. I'll try next to check the under extrusion...
Hi, I use Ultimaker Cura 4.3.0
Hi BrandonW.
I think I have the same problem. I tried to make some litophane photo but as you can see on the pic attached, a have some missed lines on the right side of the print.
So Hope I can...