Ah, well, i don't have a MakerFarm i3. Its a Schufco kit and as far as component quality goes I've been very happy with it all and generally had a trouble free experience.
I haven't used a gcode...
Type: Posts; User: squirrel
Ah, well, i don't have a MakerFarm i3. Its a Schufco kit and as far as component quality goes I've been very happy with it all and generally had a trouble free experience.
I haven't used a gcode...
Ah well i can try! Only had the i3 since start of january, got it as a kit and built it myself. Was rather confused by it all at first, particularly the marlin settings. Found a lot of examples...
Hey Printbus! Just wanted to say a quick thank you for documenting and publishing your research! Amazing work, reads like an academic paper in a peer reviewed journal, and some of my friend's...
I believe Tyson uses pronterface... I also left the servo time out at 300, but extended stepper time out from 60 to 180 which didn't seem to make a difference. Id like to say I'm stumped but to be...
Yup thats a side effect I've also noticed, but I've caught the rising temp the 1st time it happened which did freak me out some what as it seemed like its running away...
DarkAlchemist I've also...
Literally cannot run two G29 T n5 commands one after another without disconnecting Repetier as it consistently freezes on the second go.
While I've been sleeping Tyson has been researching, a lot! :) But I've just tried running G29 T n5 without the LCD connected and it still froze up on the 3rd go, which makes me think its not LCD/SD...
I do have a 5v USB charger, will give it a shot but not sure how it would work with my SD initialisation ritual as it only seems to work on only one of the 2 usb ports on my laptop. And in general...
Ive just started a print but i can try to disconnect the LCD with the card reader once its finished and see if it makes a difference, but the freezing happens regardless of where the code is coming...
Same, followed instructions on page one. I did try the marlin version that incorporates Roxy's code just to see if it would fix the freezing (and SD init fail thing) but it all went terribly wrong n...
Confirmed, although I'm using Repetier. Ive tried extending stepper timeout to 180, and i don't think power hungry servo is at fault either as it happens with usb plugged in. Hmmmmm....
Yup, same thing happens to me Tyson, on about 4 out of 10 G29s i send. Totally stumped and cant figure out what its related to or triggered by. Happens like this: it does 8 probes without a hitch,...