Thx Roxy, I will do that now. I fired up the printer still on RC7, and ai het a "printer haulted" error while hearing up...
I will do the upgrade first...
Type: Posts; User: scalci
Thx Roxy, I will do that now. I fired up the printer still on RC7, and ai het a "printer haulted" error while hearing up...
I will do the upgrade first...
Apologies for the delay...
It is a Inductive type proximity switch
Arhur wit this in mind, I also run S3D, what other oprions are there fr software?
PS. I just ordered. 4xc and 5xc this week :) :)
Hi Everyone
I need some help.
I have been running Marlin (just upgraded to the latest RC :)) for a while on a RUMBA board but never setup the endstops. I bought the OPTICAL ones.
I read a...
Hi Everyone
I am currently looking to replace my RAMPS with a Smoothieboars.
Does anyone have any further updates on this?
Rgs
What software do you guys use?
Roxy, when do you expect RC7 to goto Stable?
I am in RC5, but if the time is short I will rather wait for the stable,release.
Also look at Fusion360, I use it for my CNC and 3D printing
Hi Everyone
Can anyone assist me please?
I want to setup a proximity sensor on a RUMBA board with the MARLIN firmware.
1. How to wire it?
2. Changes in Firmware?
Hi Everyone
Is the a way to set backlash in Marlin?
rgs
Hi Roxy
thank you, I will start with this and work up.
Roxy that is what I am doing.... Is there a sweet spot?
When I went to the latest RC code I left everything at defaults except the steps... If I change one setting at a time, will It work or do...
I did the RC upgrade today :) works as the prevois version. Where can I read up on the changes?
Hi Everyone
I need some input.
I build my printer with a RAMPS 1.4, DRV8825 drivers, Latest Marlin, Nema24 steppers and threaded rods.
I had a huge wobble on the X&Y, so I replaced the...
Hi, I see on the web a few that had/have issues with calibrations and also quality. These were in May 2015. Was this solved in the current hardware and software?
Is there any update to thicj sticky?
I did mine but screwed somewhere up :(
I am now going through line n line....
Is there a way to get the current config from the Arduino?
Roxy, thank you, I will look at this now... :) my line in South Africa is a bit slow, so should have it soon...
Hi, Everyone what is the best way to upgrade to keep your configuration?
Same here have not had any issues yet.
What I am looking at now, if I should move to another firmware version, I am using Marlin currently.
Hi Everyone
I am building my own 3D printer with the RAMPS kit. Two area's I need to get done is the Hotend and extruder.
Where can I buy these from or makes the better ones?
Rgs
Scalci