Well, on the dreamer, I grabbed one end of the x axis bars with my left hand and the other end with my right hand, out toward the sides of the case. Then I pulled one hand toward my body while at the...
Type: Posts; User: dcohenour
Well, on the dreamer, I grabbed one end of the x axis bars with my left hand and the other end with my right hand, out toward the sides of the case. Then I pulled one hand toward my body while at the...
I grabbed the x axis and gave it a twist. It will make a "kaka" sound. Sounds primitive, I know, but that is what I was instructed to do by tech support. The axis was just slightly off, and that...
Hi, I followed your suggestion and it appears to have worked. See my reply to Sebastian. Thanks!
Hey Sebastian, thanks for the tip. I did drop the temp to 95 and the part just popped of are it was done. Very nice!
Also, I used the suggestion to grab the x axis bars and give them a tug to...
Hi All, I have had a FF Dreamer for about 1 week, and have been able to print four times. I am trying to print a 4.0 x 2.0 x .19 (inches) case in two halves. I am printing each half using a raft. It...