Thanks for your reply.
I have used PID autotune in the past, however I don't think this is a PID loop problem as the temperature detected changes instantaneously by a large amount.
I think I will...
Type: Posts; User: Sewyboowy
Thanks for your reply.
I have used PID autotune in the past, however I don't think this is a PID loop problem as the temperature detected changes instantaneously by a large amount.
I think I will...
Hi there,
I am having issues with my 3d printers temperature detection. It's an Arduino and RAMPS running marlin with an e3d v6.
The temperature readings seem stable but can suddenly jump ~20-30?....
OK, stupidly I had my rod lengths set wrong, I have altered it to the correct value and now it almost works, but each cm I tell the hotend to move, the hotend moves just over a cm, so do you think I...
Hi,
I just finished the build of a kossel xl 3d printer and i have done the paper test and adjusted the bed so that its level and calibrated to the center of the bed, so that the point 0,0,0 is a...