Ok so i have updated the BOM on Mouser as i have just got the part number for the Fuse. I am not sure that the one that i randomly selected the first time will work so so it may explain why it kept...
Type: Posts; User: DaveyR
Ok so i have updated the BOM on Mouser as i have just got the part number for the Fuse. I am not sure that the one that i randomly selected the first time will work so so it may explain why it kept...
Hay Jason
Good luck for the PCB. I am waiting on my second shipment of parts to come in as i think that the default ground plane is so close to the pins that i got a short somewhere.
All soldered up and a short circuit in there somewhere so in a day or so i will do it again slowly and confirm where it is. I could not see any bad soldering.
rats
Ok so got my PCB's this morning and got to soldering.... Found that i had missed 2 parts off the Mouser project list which i have updated so it should have everything.
But a bigger issue is the...
Funny you should have said that i have just found one that will fit from his ebay store and clicked purchase :) so next week should be back working with heated bed.
My camera holder had started to come up so much that after 3 hours i just stopped it. I have been trying to figure out OpenSCAD but struggling getting enough free time to do a decent job in learning...
Bill how has your printing gone. I have struggled with the last 2 parts of the bearing top and the Camera holder.
I have issues with both warping lots and coming off the print bed. The small...
Hi Jonzer
Sorry i thought that i had replied the other day. I have had to change the size of my print bed as it was not long enough to print out the bearing top or the camera holder. I have all...
I just downloaded the whole package and got them all in a single Zip file. Then extracted for the ones that i needed.
Hi Bill
Great idea and i agree about the Pi2 that may be what is needed. I thought that as i had most of the bits around i would start from a known good and then go from there. I have 2 of the...
i found on Ebay the following parts the descriptions should allow you to find them.
2 * Industrial Class 650nm 5mW 5v Red Laser Line Cross Module Glass Lens Focusable $10 (Coming from China or HK)...
Hay Jonzerb
Once i confirm if the boards work no problem. Will just be the $10 + postage.
Think they should be here by the end of next week.
For the list of components i think that this...
Ok so i have a pretty good list of all of the parts needed from Mouser as a project.
The only thing that i have not been able to get nailed down is the PTC
The MF-Rxx is the series but i am...
Oshpark is making the boards for me. They are about $10 each and you have to order a minimum of 3.
I am most likely going to make 2 which means that i should have one spare board.
Regarding...
I have got about 75% of the parts printed now and an Arduino all set up.
The first thing i have discovered is that the size of the stepper motor was not listed so the one i have which is a kysan...