Has anyone been able to alter any settings in a CreatBot's firmware? I am new to this and don't even know what type of Firmware it actually uses (supposedly a modified version of Marlin) or how to...
Type: Posts; User: Mike70515
Has anyone been able to alter any settings in a CreatBot's firmware? I am new to this and don't even know what type of Firmware it actually uses (supposedly a modified version of Marlin) or how to...
Could anyone recommend a decent 3D CAD Software that is free and similar to SolidWorks or Inventor?
From looking around in forums it seems to be a modified version of Marlin.
Do you know if any of the common Firmwares would work for the CreatBot? Or does it have to be a specific one?
Its only a millimeter smaller in diameter. However, the hole is right on the edge. I'm going to see about getting a new block machined.
Prometheus is currently out of thermistors. I had to order everything separately instead of a full hotend package. However, even if I had their thermistor, I don't know how to load a resistance table...
I'm upgrading my old hotend to a Prometheus V2 but the new heat block doesn't provide a big enough hole for the original thermistor cartridge. If I were to order one that would fit the heat block,...
The hole for the thermistor it right by the edge of the block so I'm not sure I would have enough meat to bore it out.
I am attempting to switch out an old PEEK designed hotend with a Prometheus V2. My issue is the new heat block provides a 3mm hole for a cartridge thermistor but the CreatBot’s thermistor has a 4mm...