Search:

Problem is, so far I've only figured out how to get the repetier firmware to work.
Half that is, some problems with the end stops and stuff.

Haven't got marlin to work with the lid controller...

Haven't got any luck reflashing the arduino Mega, as i don't have the original firmware yet.
Tried it with a modified version of the repetier and marlin software but no luck getting it to work yet...

The software version you mentioned before was it the windows software or the marlin firmware?
Cause I have absolutely no idea, as I'm new to this.

Edit: just found out the firmware the printer...

I'll try and check the version this afternoon, it'll be a first for me.

I've set up my retract to be 4,5mm, which solved a stringing problem I had before.
So I think that amount is adequate.

Tried the longer print again today after measuring the voltage through the potmeter with a proper multimeter.
They're set to roughly 0,5V now and the extruder stepper to 0,65V with a cooling fan.
...

On the motors? I was under the impression the drivers where overheating.

Already have the Z-hop/ vertical lift in every model i try and print.
I checked the pulleys on being fixed and they where.
Which takes me to the last possible thing that it could be, the stepper...

@Offroadbob, I had that problem aswell, when looking through the slicer settings i found the appropriate settings for the move and made it standard in any of my prints now.

So is there any way to measure the outputs and are there any settings it should be set around?

I'm a bit hesitant to meddle with those settings without knowing how much I have to adjust them.
Is there any way I can measure the outputs and is there a set amount of current needed for the...

7256

That's it, the two different shifts.

Hi guys 'n gals

So i recently bought my first 3d printer, a Delta printer.
First few prints off of it came out pretty good already, had some trouble with stringing but that was quickly fixed....