I looked at tinkered a while back, I thought there were some more advanced features in 123D that weren't available in tinkercad, I will say I don't remember what they were.
Type: Posts; User: pascal
I looked at tinkered a while back, I thought there were some more advanced features in 123D that weren't available in tinkercad, I will say I don't remember what they were.
confirmed that following the dual nozzle calibration in the sailfish instructions is causing the problem. I'll comp out the slight offset for dual printing in S3D
thanks. I just did an eprom erase and that fixed it. Thinking I screwed things up running the dual extruder alignment script. Now to figure out how to align the two extruders in FW (off just a...
added a video, really odd issue: here is a video of the issue: https://youtu.be/2LMjBBUoRSk
All was going well with my qidi tech I, just the other day I aligned the two extruders, and ran the attached script to determine what values in the fw to set for getting the two heads in alignment...
Improved the print quality a bit, though the infill is still slightly lower than the perimeter. The lower layer is touching but not overdoing it, I'll do another print tomorrow at 100 % infill and...
I haven't thought about that, makes sense! I had increased the overlap to the perimeter a while back before adjusting the extrusion properly so that makes sense, kicking of a test cube!
thanks!
Too funny, I meant 0.3 layers with a .4 nozzle.
Thanks for the help!
Looking for a little help. My qidi tech I is doing good, after some learning I thought I would dial in the calibration a bit. Printed a 20x20x10mm tall cube with 3mm layers single wall. Increased...
Am I the only one crashing 123D with regularity?
hi there. I'm new to 3D printing and loving it! I've been using 123D Design , Simplify3D and printing on a QidiTech I. results are very impressive.
The problems are with 123D Design. I'm...
I'm new and learning as I go. make a thin walled rectangle about 50mm that is hollow on the inside, then use your slicer to change the temp 5 degrees every 5 mm. On my Qidi Tech 1 pal likes...
Apologies on the links, see if these work better:
http://r.ebay.com/Zlgjvi
http://r.ebay.com/1vFosk
Based on the response in eBay it sounds like the printers are the same qidi tech 1 printer.
is there a difference between your two listings for the QIDI Tech I on Ebay? One says newest other says extra cooling fan. thank you.
http://www.ebay.com/itm/New-arrival-...8AAOSwaA5WlvM7
...
Looking on the forum the QIDI amazon and eBay seller are the same:...
I'm going to be placing an order soon on our first 3D printed. I'm new to this and not sure what I should get with it. any suggestions on filaments and accessories? For software I'll probably get...
thinking I'm going with the the QIDI tech I, will see soon!
the Robo 3D seems to show up a lot too - the flexibility in materials is appealing...
https://www.amazon.com/exec/obidos/ASIN/B0142PHFVU/ezvid02-20
also for SW if the included isn't a good choice please recommend an alternative like simplify3D which seems to support both the printers I was looking at
thanks!
Hi there. Just joined the forum today after a while of browsing.
looking for my first 3D printer. looking to get something that will last a while and preferably under the $1000 mark. I was...