Hmm, it seems I cannot create an AMF file from Inventor.. google searching ;AMF file for Inventor; doesn't come up with much, besides someone asking about it on a Autodesk forum - and getting a dumb...
Type: Posts; User: Txjeeptj
Hmm, it seems I cannot create an AMF file from Inventor.. google searching ;AMF file for Inventor; doesn't come up with much, besides someone asking about it on a Autodesk forum - and getting a dumb...
I have ruled out "overheating" of the stepper motors. I designed a large rectangle that covers the entire platform and started the print. It printed it successfully in 2hrs without freezing. The...
Annndd the new motherboard didn't do anything.... Problem still exists.
Ruled out the print file, as they printed the same x3g that I am trying to print (except they printed it successfully).
...
Contacted FlashForge, they are sending me a new motherboard. Will update w/ results.
I updated the firmware and also ReplicatorG sailfish. Tried to print again, this time it got to the second layer (an improvement..) and then froze - heaters turned off, printer reset/played the tune...
I always run the code via SD Card, I tried running it through USB/Computer to see if the SD Card slot was screwed up - but the USB/Computer froze also. The computer did not go to sleep or anything,...
I just tried to print something from Thingiverse and it froze just after laying the first layer of skirt down. It seems to be freezing sooner and sooner each time I try a print.
This time it...
I have a FlashForge Creator, which is the same thing as the original MakerBot Replicator (Wooden Box).
I have been printin via SD card for the past few months with no problems at all. All of a...
I cannot find any information regarding this on the internet. What program to use, the procedure, etc.
I currently use Autodesk Inventor to design everything for single extrusion.
Does anyone...
Hmm, I'm not sure. From what I have read, LEDs do not draw much power at all - but read this:
I completely disconnected the LEDs from the printer and the issue of it freezing has gone away. So the...
I have a FlashForge Creator which is 99% a knock off of the Makerbot Replicator 1.
I just installed LEDs to light up the chamber, and the first two prints I tried after installing the LEDs they...