Ok, i did surspect that will initially start out with a 50x50x50 cm cube. That should accommodate for a 300x300 or 240x340mm bed. Time to hit the cad and see were i end up at.
Type: Posts; User: Zuru1
Ok, i did surspect that will initially start out with a 50x50x50 cm cube. That should accommodate for a 300x300 or 240x340mm bed. Time to hit the cad and see were i end up at.
Thanks for sharing.
The ones I have found are 2 mm thick, which is fine after testing to bend them.
Now I have to figure out the length I need for my build.
How does one calculate the cube...
Hi,
I'm currently building and designing a corexy 3D printer and was wonder if I could use square aluminium tubes for the frame.
I know that one can use V-slot rails, but those are not locally...
Well I replaced the glass and got a flat bed and recalibrated the hole printer twice just to make sure and still no change.
I also tried RC7 firmware version to see if that would solve anything,...
So I changed to the RCBugFix version and disabled min_software_endstops and was able to calculate z probe offset.
Same behavior as before when printing the calibration print no matter how close the...
They are both set to true in both versions.
If I disable them (set them to false), won't that be totally removing any safety measures for travel over the a given axis length?
Does it matter if...
Update:
Tried the Marlin RCBugFix version and the same problem that I had before still prohibits me from lowering the nozzle so that I can calculate the z-probe offset.
Even if I change the Z min...
Hi,
I'm on Marlin version 1.0.2-2.
Front-left point
>>> m48 v4
SENDING:M48 V4
M48 Z-Probe Repeatability test. Version 2.00
Hi
I decided to add auto bed leveling/trimming on my printer using a PNP inductive proximity sensor switch (LJ12A3-4-Z/BY).
At the moment I have managed to get the initial set up, were to probe,...
Anyone?
I have been at it for a while and would like to fix this so that I can go on with using my printer.
Hi
I decided to add auto bed leveling/trimming on my printer using a PNP inductive proximity sensor switch (LJ12A3-4-Z/BY).
At the moment I have managed to get the initial set up, were to probe,...