OK, So I figured that I should update this post so I dont feel like I put some bad information out there. I was completely wrong about the brand of filament being a factor here. I finally stumbled...
Type: Posts; User: kcoughenour
OK, So I figured that I should update this post so I dont feel like I put some bad information out there. I was completely wrong about the brand of filament being a factor here. I finally stumbled...
Well, the best I could tell, it was coming back to the correct location. So as I was about to give up, I had a Eureka moment and decided to run the print again, still with the pause, but this time I...
OK, So I added another M code right after the filament change to heat the filament to its maximum range which is 220 before resuming the print. I started the print at 200, which is the minimum. I...
Hi,I have a Creality Ender-3 Pro and am using a PLA+ filament. I edited my firmware to enable print pausing via the M600 command inserted into my gcode so that I can change filament colors at certain...