Welp, somebody beat me to the punch with 'Luna': https://www.crowdsupply.com/great-scott-gadgets/luna
Type: Posts; User: likhalabs
Welp, somebody beat me to the punch with 'Luna': https://www.crowdsupply.com/great-scott-gadgets/luna
Luna has been renamed to Phi! Our pre-launch page is also up on Crowd Supply: https://www.crowdsupply.com/likhalabs/phi-mainboard-5lc. Check it out if you're interested!
It's printing! https://i.ibb.co/GH1n0c5/printing.gif
Another sneak peak!
Issuing an M115 (Get Firmware Version and Capabilities) command:
16734
Higher res: https://i.ibb.co/8Mk8D9h/m115.png
Driving stepper motors:
It's also RepRapFirmware. Essentially, I've split RRF between the ESP32-S3 and SAM E5 microcontroller. The web interface is Duet Web Control, and it runs on the ESP32-S3.
One thing to note is...
Oof. That's a lot of extra cost. The chip shortage did its toll on the tiniest of microcontrollers to high-end 5nm processors. Fortunately for Luna, it seems that Microchip fares a little better than...
Sure, no problem. I did say people can ask questions on this thread :)
Regarding the price, I'm looking to be in the same price range as the Duet 3 Mini 5+. That's about 129 USD. It's cheaper...
As mentioned, the board is based on the Duet 3 Mini 5+ (https://github.com/Duet3D/Duet3-Mini5plus). While the main argument for removable drivers is the replace-ability on failure, why not avoid...
You mean larger than: https://i.ibb.co/1b1zqRW/luna.png ?
Hello everyone! I’m excited to introduce Luna, a 3D printer controller with a focus on network connectivity that I've been developing for the past few months.
Here’s a little tour of the hardware...