I increased the gap, but it still happens on some areas of the print.
1006810069
I tried to take a picture. On some areas, some "strings" of the first layers lift from the raft just before the...
Type: Posts; User: Scrapenbaker
I increased the gap, but it still happens on some areas of the print.
1006810069
I tried to take a picture. On some areas, some "strings" of the first layers lift from the raft just before the...
Still the same problem :(
It feels like it happens less if I turn the filament fan on from the beginning, but maybe it happens just random?!
10051
this is the bottom of the cube with the new filament and same settings. It's much better, but still not perfect.
10047100481004910050
I just used a new roll of ABS and the same settings and the effect almost didn't happen.
Can moisture cause that effect?
Thanks
10034
If you don't cancel the print it comes out like this.
Hi guys,
my makerbot got a strange error since a while.
The printer prints the raft in a good quality and than suddenly messes up the first layer. Most of the time just the center of it.
It looks...
Hi,
I had the same problem.
https://www.youtube.com/watch?v=SvZV-lnRtj0
In my case the x-axis cable had a loose contact. It broke behind the metal pin.
10032
I was soldering the cable and now it...
Thanks for the answer!
It was the leveling, because I leveled the plattform like I was used to when it was cold, but the springs underneath the plattform seem to change due to the thermal change of...
Hi,
I own a Makerbot Replicator 2 and upgraded it with an aluminium heatbed with glas plattform, a hood and acrilic "windows".
When I use PLA everything works fine, but today I used ABS for the...