OK - I'll give that a go! - Thanks.....
Type: Posts; User: dlps73
OK - I'll give that a go! - Thanks.....
Exporting from TinkerCad as an stl file and then using ReplicatorG to convert to x3g - not sure if I would notice a 7mm difference.
Should I use that as a basis and then scale all drawings up by...
I have created a few models in TinkerCad and they always print smaller than the design i.e. a strut supposed to be 112mm printed at 105mm.
Obviously this is a calibration issue - is there a link to...
Thank you for all the replies and advice. I finally heated the extruder up to 240C and managed to melt/push the obstruction through - thanks again....
Unfortunately - doesn't deliver to Australia.....
8880
Thanks for all the replies - I've taken the fan off and the path is clear. Whatever the obstruction is it's about 24mm from the nozzle upwards (after the drive gear).
I'll try and find...
Thanks Bigo93 - I think I'll go with the clog version as it's been printing fine...
Situation - using the Utilities/Change Filament/Load Right Menu and waiting until the correct temperature - as I start pushing the filament in it appears to start feeding and then it just "skips"...