OK, so the heat bed on my prusa i3 crapped out the other day and i have a couple of questions. 1) Is it possible to fix a shorted out heat bed? 2) Has anyone used the heat beds you can buy from...
Type: Posts; User: kissfan4
OK, so the heat bed on my prusa i3 crapped out the other day and i have a couple of questions. 1) Is it possible to fix a shorted out heat bed? 2) Has anyone used the heat beds you can buy from...
is the play between the bearings and the shaft? or between the bearings and the carriage?
ok, i was able to connect to the printer through the Arduino IDE but when i click on serial monitor i just get some status info, i can not figure out how to access the configuration h file.
The end stop on mine is not moveable, two screws and that's it.
Can i ask, how are you guys accessing the firmware on these boards? I am relatively new to all of this, but i can get to it.
No it is not, i do not have measurements, but i can get them tonight, but the nozzle is off the bed in both the "x" & "y" axis when at the home position. I have changed the bed dimensions in Slic3r...
i have the same printer, and although i had a few issues with parts, i eventually threatened to send the printer back for a full refund and their attitude changed quickly. Mine also came with the PLA...
I use painters tape, and even hit it with hairspray, no curling but can be a PITA to remove. The tape is usually stuck pretty good to the part once i get it removed, then i just use some solvent,...
I am trying to get my migbot up and running and so far the test prints are coming out better than I thought they would, the only problem is they don't print center. In the settings in pronterface the...
it might be something i try. i will admit, i am not the best at coding so that is going to be my big hurdle
So i was looking into the auto bed leveling and had an idea, not sure if there is already a thread about this, but instead of having the z axis constantly in motion to compensate for an unlevel bed,...
I too order this printer, mine was missing the hot end, after a few days of emails, and me finally threatening to box it up and ship it back for a full refund they said they would mail out the hot...