Monotonic on, still at 1.0mm top layer thickness. Better, it really looks like it's dragging or over extruding at the beginning/end of the diagonal runs (every other run? hard to tell). I'll live...
Type: Posts; User: sdb999
Monotonic on, still at 1.0mm top layer thickness. Better, it really looks like it's dragging or over extruding at the beginning/end of the diagonal runs (every other run? hard to tell). I'll live...
I'm at 5 layers now at .2mm layer thickness (1.0mm top layer total thickness). Referencing examples top layer thickness:
1. 2.0mm
2. 1.0mm
3. .75mm
4. .4mm
After adjusting top layer thickness...
Ender-3 S1
Slicer: Cura
Material: ABS
Tip: .4
Temp: 240
Bed: 100
Layer Thickness: .2
Speed: 50
Cooling: off
PVA did the trick! Link below prints well and dissolves in water, in less than thirty minutes it falls out with only light brushing. Thanks for the time.
...
Thanks for the response. Yea, I've tried acetone on my ABS filament and although it softens somewhat it's not dissolving....been soaking for an hour or more. Likely some other additives in the ABS...
I've searched but haven't found this application. I'm casting an Aluminum Epoxy material in a cast aluminum host. I want to 3D print a core such that when the epoxy cures, I can dissolve the core...