Search:

I do have the heat on. I thought of using a sheet of glass with hairspray and setting the z offset... Anyone tried that yet?

AHH I think I need supports turned on for the X. There is a pocket underneath.

OK. Here is my largest print ever.

Couple of issues...

Raft problem: Same as before, but I have not tried the new setting yet.
Raft Warp: The upper right hand corner cam up a couple mm. ...

One issue I am having (before I used your settings) is separating the part from the raft. What setting affects the material between the raft and the part?

Thanks again Dragon. I am going to use you setting as a baseline to see what happens.

That site is getting some INCREDIBLE prints. If I can get them half that good I will be happy.

I did contact support and looks like the parts will be on the way.

As for the temp. I was trying to print ABS which apparently it will not do. Do you run your PLA at 35C chamber temp? I will...

Dragon,

That may have honestly been the best reply I have EVER received in a forum. Thank you VERY much...

I wanted to get that out there. I do not have time to reply point by point right...

Does anyone have a Z18? Are you getting good prints out of it?

I want to start by saying I HATE this printer. I cannot get 2 consecutive good prints from it.

Problems...

Unpacking: ...