Search:

I am almost done building my second printer and I cannot get any of the steppers to move. I have all of the limit switches, hot end thermister, motors plugged in, and mintemp and min extrusion temp...

Okay that makes much more sense, thank you. So today I plugged in the power supply, just like I did yesterday, and it fried something. I have no idea why, I literally did the exact same thing...

First while trying to fit the shield on the Mega I slipped and gouged the RAMPS board. There is a picture below, I'm not sure if it is usable.

Also, it came with these connectors that I do not...

I am not new to 3D printing and understand most of the technology quite well. Long story short, I need to build a printer for a specific application that must fit a few specifications. Keep in mind,...

Another update:

I tried a different object to print and it finished the job. I printed a circle with the spiral infill first. After that I tried the same circle with rectilinear with a successful...

Today I tried using different hosts and firmwares. I tried Pronterface using the same Marlin firmware and the same gcode I was using before and I got the same result. So this leads me to believe the...

I put the gcode in the link you gave me and it seems to be just fine; it finishes the job. Another observation is that it loses its position after it stops. I tell it to go to park position after it...

I am running Slic3r and Repetier host on a LDM printer. For some reason the printer stops printing and goes to home about 3/4 of the way through the last layer. While it prints it shows where the...

I got it to work. The filament diameter setting was not correct since I was not using a normal plastic filament. Thank you for the reply

So I have a LDM printer setup with a Rambo 1.3 board running Marlin firmware and Repetier host. I essentially built and setup the printer from the bones of an older, obsolete printer and I have...

Awesome! Thank you. What do you recommend for a power supply (Amps/Watts)? 12v will be enough for what I am doing.

I have a 3D printer that I want to install a new electronics package in. I decided to go with the Rambo 1.3 board. This board says it can use 12 or 24 volts. My questions are: What voltage should I...

A little update, I found the software package to go along with the printer, but It is very strange and poorly designed. I have successfully printed a few parts, but I am very limited by the settings....

I am fairly new to the 3D printing world, and I need some help. I have a Fab@Home model 2 printer using the snapmotors' SM HUB6 hub and SM062 motors. The only things that were given to me were the...